Skypanel Absolute FX
Posted: Wed Jan 22, 2020 6:04 pm
I'll give this question a go here.
I want to use Skypanel s60's (Mode 6) with Absolute FX triggering two colors. Basically flashing instantly from red to blue. In ML controls, Crossfade is at full for color mode.
Color Palette 1 = red
Color Palette 2 = blue
Action 1 = CP1 Dwell Time 1sec
Action 2 = CP2 Dwell Time 1sec
The S60 should snap between two colors instantly, at least that's the plan. Well it doesn't. The Skypanel seems to fade between the two colors and I can see the color picker passing through the white point as the effect runs. I tried using Presets instead, same thing. Tried a step chase, same thing.
If I do this effect with an Astera tube, it works as intended. Is there a way to get the Skypanel to behave the same way?
EOS v2.9.1
Skypanel Firmware v4.2
I want to use Skypanel s60's (Mode 6) with Absolute FX triggering two colors. Basically flashing instantly from red to blue. In ML controls, Crossfade is at full for color mode.
Color Palette 1 = red
Color Palette 2 = blue
Action 1 = CP1 Dwell Time 1sec
Action 2 = CP2 Dwell Time 1sec
The S60 should snap between two colors instantly, at least that's the plan. Well it doesn't. The Skypanel seems to fade between the two colors and I can see the color picker passing through the white point as the effect runs. I tried using Presets instead, same thing. Tried a step chase, same thing.
If I do this effect with an Astera tube, it works as intended. Is there a way to get the Skypanel to behave the same way?
EOS v2.9.1
Skypanel Firmware v4.2